Updates from build discussions on dozens of 4x4 forums.
6:41 am on Jul 16th, 2018 EDT - updated by CrazyBRONCOguy
1978 Ford Bronco Build on FullsizeBronco.com (more Ford Bronco builds)
Pulled one of the rear shafts yesterday to verify some measurements. The splines look surprisingly g...Click for CrazyBRONCOguy's full post
5:08 am on Jul 16th, 2018 EDT - updated by Panic
1964 International Harvester Scout 80 Build on BinderPlanet.com (more International Harvester Scout builds)
And I had to include another bumper picture. Im pretty happy with the outcome...Click for Panic's full post
11:55 pm on Jul 15th, 2018 EDT - updated by cj8_mustang_68
1967 Jeepster Commando Project Crapmando Build on Pirate4x4.com (more Jeepster Commando builds)
More pictures of the flat bed and some of the van...Click for cj8_mustang_68's full post
11:27 pm on Jul 15th, 2018 EDT - updated by hpclayto
Jeep Wrangler TJ Build on WranglerForum.com (more Jeep Wrangler builds)
Well things are moving a little slower than I would like. I'm only able to work on this on my off da...Click for hpclayto's full post
11:00 pm on Jul 15th, 2018 EDT - updated by marshallnoise
1979 Ford Bronco Build on FullsizeBronco.com (more Ford Bronco builds)
I went out and looked at my flywheel and measured it out. Even though I have a Ford partnumber'd fly...Click for marshallnoise's full post
10:57 pm on Jul 15th, 2018 EDT - updated by EDS
Other International Harvester Airporter Build on BinderPlanet.com (more Other builds)
I've taken a couple day break from the limo to get the trailer ready for Sturgis. Front axle looked...Click for EDS's full post
10:03 pm on Jul 15th, 2018 EDT - updated by MrKenmore
1978 International Harvester Scout II Terra Build on BinderPlanet.com (more International Harvester Scout builds)
So I decided to finally do an engine compression test. Looks like all my four cylinders are just aro...Click for MrKenmore's full post
8:46 pm on Jul 15th, 2018 EDT - updated by DonL
1999 Chevrolet Blazer 99 4 door blazer Build on BlazerForum.com (more Chevrolet Blazer builds)
So since I did the cat and o2 sensor swap, I've gotten my mileage back from 350km to about 450km a t...Click for DonL's full post
7:36 pm on Jul 15th, 2018 EDT - updated by Nicxt44191
International Harvester Scout Build on BinderPlanet.com (more International Harvester Scout builds)
Good advice. I usually weld/ grind with a half respirator with p100 pancake cartridges. I try not to...Click for Nicxt44191's full post
7:08 pm on Jul 15th, 2018 EDT - updated by superdave
1977 Jeep Grand Wagoneer DD Build on FSJNetwork.com (more Jeep Grand Wagoneer builds)
Thank you! I was flipping it around trying to figure out how it's supposed to go in there. I'm not s...Click for superdave's full post
Go to page: