Updates from build discussions on dozens of 4x4 forums.
1:02 am on Jan 16th, 2023 EDT - updated by Fireball
1946 Jeep CJ CJ-2A Build on EarlyCJ5.com (more Jeep CJ builds)
I really have nothing to add to this thread at the moment, but here's a picture of the Jeep from Tod...Click for Fireball's full post
2:32 am on Jan 15th, 2023 EDT - updated by 73 cj5
Jeep CJ 3b Act Ii Build on EarlyCJ5.com (more Jeep CJ builds)
If I get crackin' early enough tomorrow she might make some noise by the end of the day. I think I'l...Click for 73 cj5's full post
11:16 pm on Jan 14th, 2023 EDT - updated by mattzj98
Jeep Grand Cherokee Project Grocery Getter Build on FrontRange4x4.com (more Jeep Grand Cherokee builds)
The seats of course didn't go without a fight. 1 bolt in each side broke off with the impact due to...Click for mattzj98's full post
10:11 pm on Jan 12th, 2023 EDT - updated by timsresort
1953 Jeep CJ CJ3B Build on EarlyCJ5.com (more Jeep CJ builds)
The frame was finished with CJ5 length Rancho 2-1/2" springs front and rear, both axles under it. Ne...Click for timsresort's full post
9:32 pm on Jan 11th, 2023 EDT - updated by timsresort
1953 Jeep CJ CJ3B Build on EarlyCJ5.com (more Jeep CJ builds)
Backing up a little, this shows how complete the motor was. Even the 6 volt battery was still connec...Click for timsresort's full post
3:04 am on Jan 10th, 2023 EDT - updated by 73 cj5
Jeep CJ 3b Act Ii Build on EarlyCJ5.com (more Jeep CJ builds)
New engine mounts and some frame mending where the crossbar mounts. Just about done trying to fabric...Click for 73 cj5's full post
9:32 pm on Jan 8th, 2023 EDT - updated by 73 cj5
Jeep CJ 3b Act Ii Build on EarlyCJ5.com (more Jeep CJ builds)
Spring perches burned in, rear brakes installed, and the new throttle cable and such are installed...Click for 73 cj5's full post
2:47 am on Jan 8th, 2023 EDT - updated by 1947cj2a
Jeep CJ Cj-2/5 Tjs-10 Dakota Build on EarlyCJ5.com (more Jeep CJ builds)
Got most of the wiring cleaned up. Temp wired the tach and ran a wire to where it needs to be hooked...Click for 1947cj2a's full post
9:17 am on Dec 31st, 2022 EDT - updated by Taco Chris
Toyota Tacoma 3rd Gen Taco Build on FrontRange4x4.com (more Toyota Tacoma builds)
Well I still have toe in at full bump. So Im going to move the heim location on the knuckle down. Ca...Click for Taco Chris's full post
1:04 am on Dec 27th, 2022 EDT - updated by Zoomad75
Chevrolet K5 Blazer Build on 67-72ChevyTrucks.com (more Chevrolet K5 Blazer builds)
Been too cold and too busy to do anything on the t-case. But I did manage to get a correct rear bear...Click for Zoomad75's full post
Go to page: